verything you loved about Talon F7 BB with a VTX Pit switch and the proven MPU6000 Gyro! Paired with our Talon Gigawatt 6S 35A ESC and ready to be FAST!
MCU: STM32F722RET6 216MH
Proven noise free MPU6000
Buily in Betaflight OSD
Up to 8S (36V) direct battery power
Buzzer pads for external buzzer
Built in voltage monitoring resistor
5V 2A BEC
Dedicated LDO for Gyro, noise free gyro power
Dedicated LDO for OSD, cleaner OSD signal
Led strip shares 5V with 5V/2A BEC
6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
Built in camera control pin with resistor and capacitor
5 Full UARTS with RX AND TX pins
Logical pin layout for cleanest build possible
8 pin 4 IN 1 ESC plug
Remapable LED pad for additional motor output
TX3,RX3 can be used for I2C for external compass
5V, VBAT selectable VTX and CAM power
16M Blackbox flash chip
No flicker VTX pit mode switch (positive switch)
M4 Can be selected either led_strip signal or M4 signal for RPM filtering
20 X 20 mounting hole with true 25mm board dimensions
Official Betaflight Target: TalonF7V2
Please use user1 for Pit Switch Mode Switch
For the Legacy Clracingf7 target you will need to do the following:
To get Motor 4 to work please use the CLI command below using Betaflight V4.0.4. A custom hex is coming soon for 3.5.7 and 4.0.4
resource MOTOR 6 None
resource MOTOR 4 C08
Save
To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit
Looking for the perfect 6S companion for your Talon FC? Good news! The Talon Gigawatt has arrived!
The Talon Gigawatt 4-in-1 35A 6S is a new generation ESC that uses a variety of bleeding edge technologies in hardware and firmware.
The Talon Gigawatt is worth your investment.
BLHeli_32 code base
Programmable PWM frequency of up to 48KHz
Auto-timing for higher efficiency and reliability
Analog Voltage/Current sensing
Adjustable “Brake on Stop” force
Improve direction change in Bidirectional mode
One current sensor to measure the total amp draw and telemetry functions.