FLIGHT CONTROLLER F405-CTR

$39.99
or

Matek is one of the leading Flight Controller manufacturers in the Drone racing community. Matek has brought to the table the all NEW F405-CTR! This AIO has been upgraded from the original F405 to now use the MPU6000 Gyro all while giving you Betaflight OSD, MicroSD Blackbox and much much more. This all new AIO will not disappoint on race day!

We recommend the Matek VTX  to go along with the F405-CTR.

 

 

 

 

SPECS

  • MCU: 168MHz STM32F405
  • IMU: MPU6000 accelerometer/gyro (SPI)
  • Baro: BMP280 (I2C)
  • OSD: BetaFlight OSD w/ AT7456E chip
  • Blackbox: MicroSD card slot (SD/SDHC)
  • VCP, UART1, UART2, UART3, UART4, UART5
  • Built in inverter for SBUS input (UART2-RX)
  • PPM/UART Shared: UART2-RX
  • SoftSerial on TX2, S5 or S6 optional
  • Camera control on S6 or DAC optional
  • Smartaudio & Tramp VTX protocol supported
  • WS2812 Led Strip : Yes
  • Beeper : Yes
  • RSSI: Yes

 

PDB SPECS

  • Input: 6~30V (3~6S LiPo) w/TVS protection
  • PDB: 4x30A (Max.4x46A), 6 layers*2oz copper PCB
  • BEC: 5V 2A cont. (Max.3A)
  • LDO 3.3V: Max.300mA for Spektrum RX
  • Current Sensor 184A (Scale 179)
  • Battery Voltage Sensor: 1:10 (Scale 110)
  • 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
  • 6x PWM / DShot outputs without conflict
  • 5x UARTs
  • 1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
  • 4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
  • 1x pair I2C1 pads
  • 1x Side-press button for BOOT(DFU) mode
  • 36x46mm PCB with 30.5mm mounting holes
  • 10g

INCLUDES

  • w/ 1x Rubycon ZLH 35V/470uF (Low ESR)
  • w/ 6x silicon grommets M4 to M3
  • w/ 1x FR4 PCB Plate 36*36*1mm

 

Customer Reviews

Based on 1 review Write a review